Previous Next
ITEM DETAILS
Meter Reading
1,423 Hours
Serial #
rock drill attachment, shoe width 31.5", enclosed cab, AC, heater, CAT 3066 eng, 2spd travel

Inspection Report



Please note that as the buyer, you are responsible for reviewing the entire inspection report when evaluating an item.
Summary Protected by IronClad Assurance Protected by IronClad Assurance®
This excavator and rock drill is in good overall condition. Cosmetically the unit has only minor damage. Mechanically, the powertrain seems to be strong and sound but there may be more than normal play in the chassis due to being used for drilling. See the report for further details


General Appearance
Description Rating Details  
operators manual Yes
cab/operator station Could use a good cleaning. Click here to open photos and videos of this item.  
sheet metal (fiberglass) condition Minor dents and surface rust.
paint Scraped, scratched and faded.
(1)


Engine
Description Rating Details  
hour meter 1423 - Hour meter on the drill reads 604 but is inoperable. The hour meter on the compressor reads 1135.
emission control label Yes
make & model Cat 3066 Click here to open photos and videos of this item.  
serial # 7JK21159
fuel type Diesel
starter Started good
battery
turbocharger No visible leaks
exhaust system
cylinder head gasket
oil dipstick tube & bonnet
blowby (checked at idle) Minor
valve cover gasket
oil pan & gasket
injector pump No visible leaks
fuel lines & injector leaks
water pump
radiator
limited function check Started easy and ran good. The engine compartment appeared to be fairly dry and clean.
(1)


Powertrain
Description Rating Details  
drive/propel motors
final drives
limited function check Operated smooth and normal through both high and low travel speeds.


Chassis
IronPlanet pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Description Rating Details  
boom & stick condition The drill has scraped the side of the boom and the bucket cylinder. Click here to open photos and videos of this item.  
pins & bushings on boom & stick Minor wear Click here to open photos and videos of this item.  
stick length Could not lower stick to measure because of the drill Click here to open photos and videos of this item.  
roller frame
turn-table bearing Minor to moderate wear. Click here to open photos and videos of this item.  
bottom covers
limited function check Operated fine with what seemed to more than normal wear throughout.
(4)


Hydraulics
Description Rating Details  
pumps Click here to open photos and videos of this item.  
valves
hoses Possible hose leak near swing motor Click here to open photos and videos of this item.  
swing motor Wet at the top and running down sides. Could be a hose leaking
cylinders Stick cylinder wiper seal has come out of the end of the cylinder Click here to open photos and videos of this item.  
cylinder pins and bushings Minor to moderate wear
limited function check Seemed to function properly while operating. The drill drifted down after everything was shut down.
(3)


Undercarriage
Undercarriage wear percentages are estimated averages only. These percentages are based on the average measurements of the undercarriage components and may vary due to the machine application, brand of parts, or OEM specifications available.
Description Rating Details  
track tensioners
shoe width 31 1/2"
overall width of tracks (outside to outside of track shoes) 125 1/2"
grouser height 5% worn Click here to open photos and videos of this item.  
pins and bushings rotated No
track link height 5% worn Click here to open photos and videos of this item.  
pins & bushing wear (internal) 10% worn
pins & bushing wear (external) 35% worn
carrier rollers 32% won Click here to open photos and videos of this item.  
track rollers 8% worn
front idler height 5% worn Click here to open photos and videos of this item.  
sprockets Click here to open photos and videos of this item.  
limited function check Appeared to have little wear, ran out fine with no unusual noises.
(5)


Operator Station
Description Rating Details  
steps/ladders
hand rails Rusted
mirrors
glass
seats/armrests Dirty and stained Click here to open photos and videos of this item.  
seat belts
exterior lights
horn
warning lights/alarms
safety alarms
oil pressure Normal - Warning light
gauges Click here to open photos and videos of this item.  
hour meter operational? Yes
air conditioner
heater
hydraulic controls Click here to open photos and videos of this item.  
powertrain controls
control lock lever
limited function check Seemed to be functioning normally overall.
(3)


Specialty Equipment
Description Rating Details  
auxiliary power unit Caterpillar 103 - 4 cylinder engine was slow to start but ran good. There is a minor oil leak from the valve cover gasket. The radiator fins have a minor dirt build up. The oil in the engine feels gritty and looks dirty but an oil sample was not taken. Click here to open photos and videos of this item.  
auxiliary controls Click here to open photos and videos of this item.  
drill drive system Minor seepage from hose fittings. The chains are dry and rusted. There is no extra drill stem with the machine. Click here to open photos and videos of this item.  
drill shaft and bit Click here to open photos and videos of this item.  
water system Has a water leak near the tank.
dust collector Rock and dust separator is bent at the end. The dust collector bonnet around the end of the drill is torn. Click here to open photos and videos of this item.  
limited function check Very limited function check could be performed but overall the unit did seem to be functional.
(5)
 
Disputes:
This item is offered with IronClad Assurance® protection. With IronClad Assurance®, if a buyer discovers that the item is not substantially in the condition as represented in this inspection report, the buyer may submit a written dispute claim to IronPlanet. Following submission of a written dispute claim, IronPlanet will investigate the claim, re-inspecting the equipment item as necessary, and determine a fair and mutually beneficial resolution. Please note that IronPlanet inspections are performed solely for the purpose of reporting the visible condition of the equipment's major systems and attachments on the day of the inspection and do not include load testing or digging/lifting. These inspections are not designed nor intended to detect latent defects, or conditions that could only be found in connection with the physical dismantling of the equipment or the use of diagnostic tools or techniques. This inspection report includes ratings, comments, and photos of the various components of the item. Knowledgeable buyers are expected to carefully review all of the available information in the inspection report, including all photographs, in order to make the best bidding and buying decision possible.