Previous Next
ITEM DETAILS
Meter Reading
1,024 Hours
Serial #

Inspection Report



Please note that as the buyer, you are responsible for reviewing the entire inspection report when evaluating an item.
Summary Protected by IronClad Assurance Protected by IronClad Assurance®
This machine appears to be in fair condition overall. The engine and hydraulics could use leak repairs. There is some sheet metal damage and the paint is fair.


General Appearance
Description Rating Details  
sheet metal (fiberglass) condition The right side access doors will not latch. Some heavy rust through door panel. Dents and dings throughout. There is rust under the paint in the operators station. Click here to open photos and videos of this item.  
paint Scraped, scratched and faded. Click here to open photos and videos of this item.  
(2)


Operator Station
Description Rating Details  
steps/ladders
hand rails Click here to open photos and videos of this item.  
mirrors Click here to open photos and videos of this item.  
glass The windshield is missing. Click here to open photos and videos of this item.  
seats/armrests The armrests are worn and torn. Click here to open photos and videos of this item.  
seat belts
horn INOPERABLE
control lock lever
hydraulic controls Click here to open photos and videos of this item.  
steering controls
powertrain controls Click here to open photos and videos of this item.  
oil pressure 80 psi.
exterior lights operational Yes - Not all operable Click here to open photos and videos of this item.  
engine warning lights operational The coolant temperature light keeps flashing. Click here to open photos and videos of this item.  
travel alarm operational Undetermined
gauges operational Yes - Has non O.E.M. gauges added. Switch panel has wires hanging loose. Click here to open photos and videos of this item.  
hour meter operational No
air conditioner operational No Click here to open photos and videos of this item.  
heater operational Yes
limited function check The components that were checked performed properly with wear and damage noted above.
(10)


Engine
Description Rating Details  
hour meter 1024 hours showing - Actual hours are unknown.
make & model Cat 3116 Click here to open photos and videos of this item.  
serial # 9Z12778
emission control label Exempt
starter Appears to be recently replaced. Click here to open photos and videos of this item.  
battery The engine required a jump-start.
turbocharger Click here to open photos and videos of this item.  
exhaust system Click here to open photos and videos of this item.  
cylinder head gasket
oil dipstick tube & bonnet Click here to open photos and videos of this item.  
blowby (checked at idle) Moderate
valve cover gasket
oil pan & gasket Yes - Covered with oil Click here to open photos and videos of this item.  
injector pump Seeping fuel
fuel line & injector leaks The governor was leaking. The unit appears to have 2 recently replaced injector nozzles.
water pump Undetermined - Coolant was seen in the rear radiator guard area from an unknown source.
radiator Took 7 gallons of coolant before running for inspection. May have leaks but none were pin-pointed during the inspection.
limited function check After jump-starting with ether, the engine ran well and sounded good. All oil leaks could not be identified due to oil covering most of the engine. The engine coolant and temperature warning lights were flashing during the inspection. See the oil sample analysis for the engine which indicates possible engine wear. Click here to open photos and videos of this item.  
(7)


Powertrain
Operational test is limited to low speed in a confined flat area without load. Full transmission shifting and range functionality cannot be fully verified. Inspector listens for abnormal noises, observes leaks and notes physical damage.
Description Rating Details  
transmission type Hydrostatic
steering brakes Click here to open photos and videos of this item.  
service brake
drive/ propel motors
final drives
limited function check Functioned well when checked without a load. The transmission was low on oil.
(1)


Chassis
IronPlanet pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Description Rating Details  
lift arm condition Click here to open photos and videos of this item.  
upper lift arm pins & bushings Minor wear
tilt linkage pins and bushings Minor wear Click here to open photos and videos of this item.  
bucket pins & bushings Excessive wear Click here to open photos and videos of this item.  
equalizer bar Minor wear at the pivot points.
pivot shafts
roller frame Undetermined - Packed with mud and debris, could not properly inspect. Click here to open photos and videos of this item.  
belly pans Bent and covered with oil from undetermined sources. Click here to open photos and videos of this item.  
limited function check The main chassis components functioned properly with minor to excessive wear in the pivot points.
(5)


Hydraulics
Description Rating Details  
pumps Leaking oil Click here to open photos and videos of this item.  
valves Leaking oil
hoses Many are covered with oil, could not determine where leaks were. Click here to open photos and videos of this item.  
cylinders Click here to open photos and videos of this item.  
cylinder pins and bushings Minor wear Click here to open photos and videos of this item.  
limited function check The system performed well when checked without a load. The fluid reservoir was low. Click here to open photos and videos of this item.  
(5)


Undercarriage
Undercarriage wear percentages are estimated averages only. These percentages are based on the average measurements of the undercarriage components and may vary due to the machine application, brand of parts, or OEM specifications available.
Description Rating Details  
track tensioners The left track was loose, it was undetermined if the tensioner would hold. Click here to open photos and videos of this item.  
shoe width 22"
overall width of tracks (outside to outside of track shoes) 8' 2"
grouser height 38% worn Click here to open photos and videos of this item.  
pins and bushings rotated No
track link height 48% worn Click here to open photos and videos of this item.  
pins & bushing wear (internal) Lubricated track, wear percentage not available.
pins & bushing wear (external) 94% worn
carrier rollers L/S 27% worn, R/S 4% worn Click here to open photos and videos of this item.  
track rollers Covered with rock guards, could not measure.
front idler height L/S 85% worn, R/S 91% worn - Swing link bearings show excessive play. Click here to open photos and videos of this item.  
sprockets Showing moderate wear. Click here to open photos and videos of this item.  
limited function check The undercarriage was functional under no load conditions with wear as noted above.
(6)


Specialty Equipment
Description Rating Details  
bucket condition 97.4" wide showing heavy wear and weld modifications to the rear and bottom of the bucket. Click here to open photos and videos of this item.  
cutting edge, shanks, & teeth 1 tooth is missing and the rest have heavy wear. The edge is non reversible. Click here to open photos and videos of this item.  
(2)


Additional Photos
(21)
 

Oil Sample Analysis
  engine hydraulic
date of analysis Dec 17, 2003 Dec 17, 2003
analysis by Spectro Spectro
Tin 9 PPM 0 PPM
Chromium 2.7 PPM 0.1 PPM
Copper 315 PPM 1 PPM
Nickel 1.3 PPM 0 PPM
Lead 137 PPM 0 PPM
Magnesium 218 PPM 6 PPM
Water 10 % 0 %
Silver 1.7 PPM 0 PPM
Iron 215 PPM 14 PPM
Silicon 43 PPM 5 PPM
Sodium 249 PPM 1 PPM
Aluminum 11 PPM 1 PPM
Glycol Y N
Disputes:
This item is offered with IronClad Assurance® protection. With IronClad Assurance®, if a buyer discovers that the item is not substantially in the condition as represented in this inspection report, the buyer may submit a written dispute claim to IronPlanet. Following submission of a written dispute claim, IronPlanet will investigate the claim, re-inspecting the equipment item as necessary, and determine a fair and mutually beneficial resolution. Please note that IronPlanet inspections are performed solely for the purpose of reporting the visible condition of the equipment's major systems and attachments on the day of the inspection and do not include load testing or digging/lifting. These inspections are not designed nor intended to detect latent defects, or conditions that could only be found in connection with the physical dismantling of the equipment or the use of diagnostic tools or techniques. This inspection report includes ratings, comments, and photos of the various components of the item. Knowledgeable buyers are expected to carefully review all of the available information in the inspection report, including all photographs, in order to make the best bidding and buying decision possible.