Previous Next
ITEM DETAILS
Meter Reading
3,512 Hours
Serial #
103.5" wide PAT blade, CAT 3046 eng, powershift trans, shoe width 18", canopy

Inspection Report



Please note that as the buyer, you are responsible for reviewing the entire inspection report when evaluating an item.
Summary Protected by IronClad Assurance Protected by IronClad Assurance®
Please see the Inspection Report and All Photos for more details


General Appearance
Description Rating Details  
cab/operator station The seat cushions are torn and separating from the frame.
sheet metal (fiberglass) condition Click here to open photos and videos of this item.  
paint Chipped, scraped and scratched with fading. Click here to open photos and videos of this item.  
(2)


Engine
Description Rating Details  
hour meter 3512 Click here to open photos and videos of this item.  
make & model Cat 3046 Click here to open photos and videos of this item.  
serial # 5XK 08488
emission control label None seen
fuel type Diesel
starter
battery
exhaust system The stack turnout is dented. Click here to open photos and videos of this item.  
cylinder head gasket
oil dipstick tube & bonnet
blowby (checked at idle) Minor
valve cover gasket Click here to open photos and videos of this item.  
oil pan & gasket
injector pump
fuel line & injector leaks None seen
water pump
radiator
limited function check The engine started instantly, ran well and sounded good. See the oil sample analysis for the engine.
(4)


Powertrain
Operational test is limited to low speed in a confined flat area without load. Full transmission shifting and range functionality cannot be fully verified. Inspector listens for abnormal noises, observes leaks and notes physical damage
Description Rating Details  
transmission type Powershift
torque converter
steering clutches
steering brakes
service brake
final drives
limited function check The powertrain pulls and shifts out well in all forward and reverse gears.


Chassis
IronPlanet pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Description Rating Details  
push arm/C-frame condition
push arm/C-frame rear pivot points Moderate to excessive wear - The pin is backing out of the frame. Click here to open photos and videos of this item.  
tilt/angle linkage pins & bushings Minor to moderate wear
blade trunnions or bushings Moderate wear Click here to open photos and videos of this item.  
blade lift linkage pins & bushings Minor wear
roller frame
belly pans Wet with oil under the transmission. Click here to open photos and videos of this item.  
limited function check The chassis was functional with minor to excessive wear at the pivot points. Click here to open photos and videos of this item.  
(4)


Hydraulics
Description Rating Details  
pumps
valves
hoses Minor chaffing
cylinders Click here to open photos and videos of this item.  
cylinder pins and bushings Minor wear
limited function check The system performed smoothly and responsively.
(1)


Undercarriage
Undercarriage wear percentages are estimated averages only. These percentages are based on the average measurements of the undercarriage components and may vary due to the machine application, brand of parts, or OEM specifications available.
Description Rating Details  
track tensioners The left track seems loose. Click here to open photos and videos of this item.  
shoe width 18" Click here to open photos and videos of this item.  
overall width of tracks (outside to outside of track shoes) 77"
grouser height 63% worn
pins and bushings rotated No
track link height 18% worn - This is a Berco track link, wear percentage given is to Cat specifications. Click here to open photos and videos of this item.  
pins & bushing wear (internal) Lubricated track, wear percentage not available.
pins & bushing wear (external) 0-5% worn
carrier rollers 120% + worn - The inside guide flange is worn off the rollers on both sides of the machine. The right side has flat spots. Click here to open photos and videos of this item.  
track rollers 60 to 86% worn Click here to open photos and videos of this item.  
front idler height 12% worn Click here to open photos and videos of this item.  
sprockets Click here to open photos and videos of this item.  
limited function check The undercarriage functioned well in no load check with usual noise and grinding. Wear percentages given are to Cat specifications. Berco track links are installed on this machine.
(7)


Operator Station
Description Rating Details  
steps/ladders
hand rails
mirrors
seats/armrests The cushions are torn and the adjuster is seized up. The seat back is separating from the frame. Click here to open photos and videos of this item.  
seat belts
horn
exterior lights
engine warning lights/alarms
back up alarm
oil pressure 60 psi @ idle
gauges Click here to open photos and videos of this item.  
hour meter operational Yes
hydraulic controls Click here to open photos and videos of this item.  
steering controls
powertrain controls Click here to open photos and videos of this item.  
control lock lever
limited function check The main cab components were functional and the controls were responsive. Click here to open photos and videos of this item.  
(5)


Specialty Equipment
Description Rating Details  
blade condition 103 1/2" wide with minor dents in the moldboard. Click here to open photos and videos of this item.  
cutting edge condition The reversible edge has been turned. Click here to open photos and videos of this item.  
(2)


Additional Photos
(1)
 

Oil Sample Analysis
  engine hydraulic
date of analysis Aug 23, 2002 Aug 23, 2002
analysis by Spectro Spectro
Tin 1 PPM 1 PPM
Chromium 7.6 PPM 0 PPM
Copper 9 PPM 1 PPM
Nickel 0.7 PPM 0 PPM
Lead 3 PPM 0 PPM
Magnesium 300 PPM 202 PPM
Water 0 % 0 %
Silver 0 PPM 0.2 PPM
Iron 69 PPM 3 PPM
Silicon 21 PPM 7 PPM
Sodium 6 PPM 0 PPM
Aluminum 14 PPM 2 PPM
Glycol N N
Disputes:
This item is offered with IronClad Assurance® protection. With IronClad Assurance®, if a buyer discovers that the item is not substantially in the condition as represented in this inspection report, the buyer may submit a written dispute claim to IronPlanet. Following submission of a written dispute claim, IronPlanet will investigate the claim, re-inspecting the equipment item as necessary, and determine a fair and mutually beneficial resolution. Please note that IronPlanet inspections are performed solely for the purpose of reporting the visible condition of the equipment's major systems and attachments on the day of the inspection and do not include load testing or digging/lifting. These inspections are not designed nor intended to detect latent defects, or conditions that could only be found in connection with the physical dismantling of the equipment or the use of diagnostic tools or techniques. This inspection report includes ratings, comments, and photos of the various components of the item. Knowledgeable buyers are expected to carefully review all of the available information in the inspection report, including all photographs, in order to make the best bidding and buying decision possible.