Scrapes, Dents and damage; Surface rust in paint loss areas
Serial Number / VIN
Control Station
Steps/Ladders
The left side cat walk step is bent. The right side step is bent
Hand Rails
The handrails are bent, broken, and loose.
Mirrors
Missing
Glass
Seats/Armrests
Dirty; Burn holes; Torn cover; Damaged cushions
Seat Belts
Dirty
Horn
Inoperable
Safety lock out/stop
Inoperable
Hydraulic Controls
Loose; Damaged boots
Steering Controls
Damaged boots
Powertrain Controls
Oil Pressure
The fault indicator shuts off after the engine oil pressure rises.
Exterior Lights Functional
No
Engine Warning Lights
The water level, hydraulic level, and the hydraulic temperature lights stay on.
Travel Alarm
Inoperable
Gauges
Functional; Some inoperable; The temp gauge is inoperable
Hour Meter/Odometer
Functional; 14,915 Hours
- IronPlanet makes no guarantees as to actual hours/miles; we can only report what can be visually observed.
Air Conditioner
Inoperable; The fan only runs on high speed.
Heater
Inoperable; The fan only runs on high speed.
Limited Function Check (cs)
The components that were checked functioned except as noted. There are loose wires in the cab. A/C & heat control knobs missing
Hour Meter/Odometer
Engine
Engine Make and Model
Engine make: Cummins; KT19C engine; Serial #: 37138399
Fuel Type
Diesel
Emission Control Label
None found
Blow by @ idle (subjective observation)
Minimal
Starter
Turbo or Blower
Operational
Injector Pump
Operational
Exhaust System
Muffler missing
Radiator
Head Gasket Leaks
None seen
Oil Leaks
There is oil and dirt residue at the sides, rear and bottom of the engine.
Fuel Leaks
None seen
Cooling System Leaks
None seen
Limited Function Check
The engine started and ran during a limited check. See oil report.
Blow by @ idle (subjective observation)
Drivetrain
Operational test is limited to low speed in a confined flat area without load. Differential interlocks, full transmission shifting and functionality of all drive axles cannot be fully verified. Inspector listens for abnormal noises, observes leaks and notes physical damage.
Drive Motors
Final Drives
Limited Function Check
The drivetrain functioned during a limited low speed check without a load.
Hydraulics
Pumps (Hydraulics)
Wet with residue; There is a leak at the left pump and stroke control.
Hydraulic Motors
Valves
Seepage; Wet with residue
Hydraulic Tank
Sight glass leak / seepage
Hoses (Hydraulics)
Worn; Weathered
Cylinders
The bucket cylinder and the right boom cylinder are leaking.
Cylinder Pins and Bushings
Wear consistent with hours and age; Loose
Limited Function Check
The hydraulic system performed with wear and / or leaks as noted. See oil report.
Hydraulics #1
Chassis
IronPlanet turn-table bearing and pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Boom Condition
Stick Condition
Boom Base Pin and Bushings
Wear consistent with hours and age
Pin and Bushings Boom to Stick
Wear consistent with hours and age
Pin and Bushings Stick to Bucket
Wear consistent with hours and age
Stick Length
16' 6" Stick Length
Turn-table Bearing
Performs within tolerance expected for age and hours
Bottom Covers
Bent; Missing covers; Oily
Swing Motor
Roller Frames
Limited Function Check (Backhoe)
The main components were functional with visible pivot point wear.
Chassis #1
Undercarriage
Undercarriage components photos (links, bushings, sprockets, idlers, rollers, grousers) are selected as representative. Bidders are encouraged to review photos using the zoom feature to judge condition in detail.
Overall width (outside to outside of shoes)
14' 6" Overall width
Track Tensioners
See photos; Loose track; Uneven tension
Shoe Width
44" shoe width
Grouser height
44 mm
Track link wear
See photos
Pins and Bushings Turned?
No
Pins and bushing wear
See photos
Carrier rollers wear
See photos
Track rollers wear
See photos
Front idler wear
See photos
Sprockets
Worn; See photos
Undercarriage #1
Specialty
Excavator Bucket Condition
60" Bucket; Worn; Cracked; Weld repaired; Plated; Hard surfaced
Backhoe / Excavator Bucket Cutting Edge
Scalloped edge between teeth
Backhoe / Excavator Bucket Shanks and Teeth
Cracked welds; The teeth are worn.
Specialty #1
Oil Sample Analysis
Engine
Hydraulic
date of analysis
Oct 21, 2009
Oct 21, 2009
Silicon
17 PPM
1 PPM
Lead
1 PPM
1 PPM
Tin
5 PPM
0 PPM
Copper
11 PPM
21 PPM
Aluminum
12 PPM
3 PPM
Silver
0 PPM
0.2 PPM
Nickel
2.4 PPM
0.1 PPM
Chromium
1.7 PPM
0.2 PPM
Iron
52 PPM
12 PPM
Glycol
NEG
N/A
Water
NEG
NEG
Fuel
<5%
N/A
Note: This condition inspection report is the result of an impartial, systematic, documented process focused on the establishment of the general, overall mechanical condition of a piece of equipment, or of a vehicle, at a specific time. The purpose of the inspection is to establish the "as-is" operational capability of the machine. It is not a performance or load test on the equipment.
Pickup Terms Failure to follow these terms may result in the seller turning away the attempt of your driver to pick up the purchased item.
Buyer will be responsible for any transportation charges issued by the driver.
Location: Kansas, United States
Zip/Postal Code: 66054
(Jefferson County)
The purchase of this item is subject to Kansas sales tax unless certain conditions are met.
Hours: 8am-4pm M-F
Call at least one day in advance to schedule pickup.
NO LOADING DOCK AVAILABLE: Only RGN and trailers with ramps can be used for pickup.
Driver MUST bring a copy of the IronPlanet Transportation Release to pick the item up.
888-433-5426
