Performs within the tolerances expected for age and type of equipment
Although performing, shows indication of needing repair or replacement
Needs immediate repair/replacement. Requires work if it is to perform as expected
NOTE: This item is offered as-is, where-is with No IronClad Assurance. IronPlanet claims no responsibility for the condition or description. This item does not include any protection offered by IronClad Assurance.
General Appearance
CE Certification Label
No
Paint
There is new paint in some areas with paint over dirt, grease and rust. Scratched and chipped
Sheet Metal (fiberglass) condition
Minor dents/ scrapes, dents and damage with surface rust in paint loss areas
General Appearance #1
Control Station
Steps/Ladders
The right side steps are bent and loose.
Hand Rails
The right side hand rail is broken.
Mirrors
The left side mirror is missing.
Glass
Seats/Armrests
Seat Belts
Horn
Functional
Safety lock out/stop
Hydraulic Controls
Steering Controls
Drivetrain Controls
Exterior Lights Operational
Yes; The boom light is inoperable.
Engine Warning Lights
Functional
Travel Alarm
Functional
Gauges
Functional
Hour Meter/Odometer
Functional 6 Hours
- IronPlanet makes no guarantees as to actual hours/miles; we can only report what can be visually observed.
Indication of Additional Hours
Seller comments there are 6310 hours on original meter
Air Conditioner
Functional
Heater
Functional
Limited Function Check
The main components functioned during a limited check
Hour Meter/Odometer
Engine
Engine Make and Model
Mitsubishi SR-Y2TAA-2
Fuel Type
Diesel
Emission Control Label
US EPA certification label
Blow by @ idle (subjective observation)
Minimal
Starter
Turbo or Blower
Operational
Injector Pump
Operational
Exhaust System
Radiator
Head Gasket Leaks
None seen
Oil Leaks
None seen
Fuel Leaks
None seen
Cooling System Leaks
None seen
Limited Function Check
After jump starting the engine ran during a limited check.; See oil report. Threre is a missing battery cap
Emission Control Label
Drivetrain
Operational test is limited to low speed in a confined flat area without load. Differential interlocks, full transmission shifting and functionality of all drive axles cannot be fully verified. Inspector listens for abnormal noises, observes leaks and notes physical damage.
Drive Motors
Final Drives
Limited Function Check
The drivetrain was operational with noise during a limited low speed check without a load.
Drivetrain #1
Hydraulics
Pumps (Hydraulics)
Residue
Hydraulic Motors
Residue
Valves
Residue
Hydraulic Tank
High oil level
Hoses (Hydraulics)
Residue
Auxiliary Hydraulic Plumbing
Yes, not operationally checked
Cylinders
Cylinder Pins and Bushings
Limited Function Check
The hydraulic system was operational during a limited check without a load.; See oil report.
Hydraulics #1
Chassis
IronPlanet pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Boom Condition
Scratched
Stick Condition
Scratched
Boom Base Pin and Bushings
Wear consistent with hours and age
Pin and Bushings Boom to Stick
Wear consistent with hours and age
Pin and Bushings Stick to Bucket
Wear consistent with hours and age
Stick Length
228"
Turn-table Bearing
Seal lip damage
Bottom Covers
Dented, oily residue
Swing Motor
Roller Frames
Limited Function Check (Backhoe)
The main components were functional with minimal wear. There are damaged guards on the chassis
Chassis #1
Undercarriage
Undercarriage components photos (links, bushings, sprockets, idlers, rollers, grousers) are selected as representative. Bidders are encouraged to review photos using the zoom feature to judge condition in detail.
Overall width (outside to outside of shoes)
193"
Track Tensioners
See photos
Shoe Width
39 1/2"
Grouser Height Measurement
34mm
Track link wear
See photos
Pins and Bushings Turned?
No
Pins and bushing wear
See photos
Carrier rollers wear
See photos
Track rollers wear
See photos
Front idler wear
See photos
Sprockets
See photos
Limited Function Check (Undercarriage)
The main components functioned normally with minor wear and several bent track shoes
Undercarriage #1
Specialty
Excavator Bucket Condition
6.54 yard bucket, worn, cracked, weld repairs
Backhoe / Excavator Bucket Shanks and Teeth
Some missing, others scalloped and worn
Backhoe / Excavator Bucket Shanks and Teeth
Worn
Thumb
Hydraulic
Specialty #1
Oil Sample Analysis
Engine
Hydraulic
date of analysis
Sep 22, 2009
Sep 22, 2009
Silicon
6 PPM
25 PPM
Lead
8 PPM
1 PPM
Tin
1 PPM
1 PPM
Copper
4 PPM
12 PPM
Aluminum
1 PPM
5 PPM
Silver
0 PPM
0 PPM
Nickel
0.5 PPM
0 PPM
Chromium
0.3 PPM
1.7 PPM
Iron
10 PPM
112 PPM
Glycol
NEG
N/A
Water
NEG
NEG
Fuel
<5%
N/A
Note: This condition inspection report is the result of an impartial, systematic, documented process focused on the establishment of the general, overall mechanical condition of a piece of equipment, or of a vehicle, at a specific time. The purpose of the inspection is to establish the "as-is" operational capability of the machine. It is not a performance or load test on the equipment.
Pickup Terms Failure to follow these terms may result in the seller turning away the attempt of your driver to pick up the purchased item.
Buyer will be responsible for any transportation charges issued by the driver.
Location: Texas, United States
(Harris County)
The purchase of this item is subject to Texas sales tax unless certain conditions are met.
Call at least one day in advance to schedule pickup.
NO LOADING DOCK AVAILABLE: Only RGN and trailers with ramps can be used for pickup.
Driver MUST bring a copy of the IronPlanet Transportation Release to pick the item up.
Unit is at a locked facility. Must call Check Blackenberry at 801-509-1727 to make pickup arrangements.
Powertrain Coverage. Covers major drive train components- engine, torque hubs, transmission & front
and rear axles - and more
Available in North America. May be purchased by residents of U.S. and Mexico only, for equipment operated
within U.S., Mexico or Canada.
OEM parts and service. All repairs are made by an OEM authorized repair facility with genuine OEM replacement
parts installed by OEM trained technicians.
888-433-5426
