Enclosed Cab, A/C, Heater, Passenger Seat, Mercedes Benz OM502LA Engine, Alison Transmission, 6x6, Retarder, 29.5R25 Tires, Auto Lube, Fire Suppression System, No CE certificate available from seller - CE mark on machine
Meter Reading:
7,413 Hours
Serial Number:
Location:
GAUTENG, South Africa
Shipping:
See shipping details for important pickup requirements and to get a shipping estimate
Inspection Report :
Protected by IronClad Assurance
Payment:
Payment due within 3 business days after auction. See Details
No CE certificate available from seller - CE mark on machine
Paint
Blemishes where decals have been removed; Scratches; Chips
Sheet Metal (Fiberglass) Condition
Dents; Cracks
Steps/Ladders
See photos for condition
Hand Rails
Loose on left side
CE Certificate Available
Control Station
Mirrors
No visible damage
Glass
No visible damage
Seats/Armrests
Missing armrest; Right side armrest missing
Seat Belts
Operational
Horn
Operational
Hydraulic Controls
Damaged boots; Panel around lever is missing
Steering Control
Drivetrain Controls
Oil Pressure
The fault indicator shuts off after the engine oil pressure rises.
Exterior Lights Operational
Yes; Rear lights are missing
Warning Lights
Operational
Travel Alarm
Operational
Gauges
Operational
Hour Meter/Odometer
7,413 hrs, Operational hour meter
- IronPlanet makes no guarantees as to actual hours/miles; we can only report what can be visually observed.
Air Conditioner
Operational
Heater
Operational
Interior
Headliner: Damaged; Dash plastic: Damaged
Limited Function Check (cs)
The main components are in place and operational.
Hour Meter/Odometer (Start)
Engine
Fuel Type
Diesel
Emission Control Label
None found
Blow by @ idle (subjective observation)
Minor
Starter
Operational
Turbo or Blower
Operational
Fuel System
Operational
Exhaust System
No visible damage
Radiator
Oil Leaks
None seen
Fuel Leaks
None seen
Cooling System Leaks
None seen
Limited Function Check (Engine)
After jump starting, the engine ran. The engine would not re-start after shutting down without jump starting.
Blow by @ idle (subjective observation)
Drivetrain
Operational test is limited to low speed in a confined flat area without load. Differential interlocks, full transmission shifting and functionality of all drive axles cannot be fully verified. Inspector listens for abnormal noises, observes leaks and notes physical damage.
Transmission
Operational
Front Drive Axle
Center Drive Axle
Rear Drive Axle
Final Drives
Limited Function Check
The drivetrain was operational.
Drivetrain #1
Hydraulics
Pumps (Hydraulics)
Valves
Hydraulic Tank
Low oil level
Hoses (Hydraulics)
Dripping leak from left dump body cylinder hose
Dump Body Cylinders
Minor to moderate pin and bushing movement
Steering Cylinders
Seepage on the right cylinder; Minor to moderate pin and bushing movement
Limited Function Check
The hydraulic system was operational except as noted.
Hydraulics #1
Chassis
IronPlanet pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Articulating Center Pins
Minor movement
Oscillating Hitch Wear
Minor movement
Frame Condition
Weld repair; Plated
Suspension Cylinders
Suspension Trunnions
Limited Function Check
The main chassis components functioned during a limited check.
Master Cylinder/Brake Control
Brake Lines/Hoses
Park Brake
Stopped from a slow roll
Limited Function Check
The brake system functioned, stopping and holding the machine.
Tire Condition
Cuts; Gouges
Wheel Condition
Wheel Studs, Nuts, Lugs
Bed Body
Minor dents; Surface rust; 40m3 Coal Body
Bed Liner
Worn
Bed Pads
1 x missing
Hinge Points
Minor to moderate movement
Limited Function Check
The main chassis components were operational in a limited check.
Chassis #1
Disputes:
This item is offered with IronClad Assurance® protection. With IronClad Assurance®, if a buyer discovers that the item is not substantially in the condition as represented in this inspection report, the buyer may submit a written dispute claim to IronPlanet. Following submission of a written dispute claim, IronPlanet will investigate the claim, re-inspecting the equipment item as necessary, and determine a fair and mutually beneficial resolution. Please note that IronPlanet inspections are performed solely for the purpose of reporting the visible condition of the equipment''s major systems and attachments on the day of the inspection and do not include load testing or digging/lifting. These inspections are not designed nor intended to detect latent defects, or conditions that could only be found in connection with the physical dismantling of the equipment or the use of diagnostic tools or techniques. This inspection report includes ratings, comments, and photos of the various components of the item. Knowledgeable buyers are expected to carefully review all of the available information in the inspection report, including all photographs, in order to make the best bidding and buying decision possible.
Buyer is responsible for all costs related to transporting the item.
Item must be picked up within 8 business days of the auction, or the buyer will incur storage charges.
The location information will be provided once full payment has been received.
Pickup Terms Failure to follow these terms may result in the seller turning away the attempt to pick up the purchased item.
Hours: 7am to 7pm
You must call at least 24 hours in advance to schedule pickup
No Loading Dock, Ramps, or Forklift Available: Only RGN or trailers with ramps can be used to pick up this item at this location. Seller will not allow item to be loaded on a step-deck or flatbed trailer without the appropriate ramps.
Driver MUST bring a copy of the IronPlanet Transportation Release to pick the item up.
Within 3 business days after the auction, the buyer must submit full payment, including applicable taxes and fees.
Buyer must pay a transaction fee, based on the final selling price:
Final Selling Price
Transaction Fee
€1 to €5,000
10% of the final selling price
€5,000 to €31,800
3.85% of the final selling price (min €500)
Above €31,800
€1,225
Payment can be made by wire transfer (recommended), certified bank check (U.S. customers only), or credit card (when full payment amount is $5,000 or less).
All bids are binding and cannot be retracted. Failure to make full payment will result in a Default Fee.
If you are looking to finance your purchase, we recommend you get pre-approved in advance of the auction. Here is a company we recommend who specialize in equipment financing:
Cat Financial
Financing for the way you work Your business is always changing, and so are your financial needs. You need quality equipment to get your work done and financing solutions that make sense for you. Count on a company that understands the work you do.
Warranty by Premium 2000
