Enclosed Cab, A/C, Heater, Passenger Seat, Mercedes Benz OM502LA Engine, 6 Speed Alison Transmission, 6x6, Retarder, Auto Lube, Fire Suppression System, Reversing Camera, 29.5R25 Tires, No CE certificate available from seller - CE mark on machine
Meter Reading:
6,386 Hours
Serial Number:
Location:
GAUTENG, South Africa
Shipping:
See shipping details for important pickup requirements and to get a shipping estimate
Inspection Report :
Protected by IronClad Assurance
Payment:
Payment due within 3 business days after auction. See Details
No CE certificate available from seller - CE mark on machine
Paint
Blemishes where decals have been removed; Scratches; Chips
Sheet Metal (Fiberglass) Condition
Minor dents/scratches; Dents; Surface rust on mudguards
Steps/Ladders
See photos for condition; Minor bends
Hand Rails
No visible damage
General Appearance #1
Control Station
Mirrors
No visible damage; Heated; Electric
Glass
No visible damage
Seats/Armrests
Damaged armrest; Top of armrests are out of place but are in cab
Seat Belts
Operational
Horn
Inoperable
Hydraulic Controls
Engine auto-rev function not fitted
Steering Control
Minimal steering wheel play; Steering will continue to operate when steering wheel is let go
Drivetrain Controls
Oil Pressure
The fault indicator shuts off after the engine oil pressure rises.
Exterior Lights Operational
Yes; Some inoperable
Warning Lights
Operational
Travel Alarm
Operational
Gauges
Operational
Hour Meter/Odometer
6,386 Hours; Operational hour meter
- IronPlanet makes no guarantees as to actual hours/miles; we can only report what can be visually observed.
Air Conditioner
Does not cool
Heater
Operational
Interior
Good overall condition
Limited Function Check (cs)
The main components operated except as noted.; Passenger seat will not stay in stowed position
Hour Meter/Odometer (Start)
Engine
Fuel Type
Diesel
Emission Control Label
None found
Blow by @ idle (subjective observation)
Minor
Starter
Operational
Turbo or Blower
Operational
Fuel System
Operational
Radiator
Limited Function Check (Engine)
After jump starting, the engine ran. The engine would not re-start after shutting down without jump starting.; Engine cover could not open; unable to determine condition of some components
Engine #1
Drivetrain
Operational test is limited to low speed in a confined flat area without load. Differential interlocks, full transmission shifting and functionality of all drive axles cannot be fully verified. Inspector listens for abnormal noises, observes leaks and notes physical damage.
Transmission
Operational
Front Drive Axle
Center Drive Axle
Seepage
Rear Drive Axle
Seepage
Final Drives
Limited Function Check
The drivetrain was operational.
Drivetrain #1
Hydraulics
Pumps (Hydraulics)
Seepage; Steering pump continues to operate when it should be idle
Valves
Seepage
Hydraulic Tank
Low oil level
Hoses (Hydraulics)
Seepage
Dump Body Cylinders
Minor to moderate pin and bushing movement
Steering Cylinders
Seepage on the right cylinder; Dripping leak on the left cylinder
Limited Function Check
The hydraulic system was operational without a load.
Valves
Chassis
IronPlanet pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Articulating Center Pins
Minor movement
Oscillating Hitch Wear
Minor movement
Frame Condition
Suspension Cylinders
Rubber boot damage
Suspension Trunnions
Bushing damage
Limited Function Check
The main chassis components functioned during a limited check.
Master Cylinder/Brake Control
Brake Lines/Hoses
Park Brake
Stopped from a slow roll
Limited Function Check
The brake system functioned, stopping and holding the machine.
Tire Condition
Cuts; Gouges
Wheel Condition
Wheel Studs, Nuts, Lugs
Bed Body
Surface rust; Cracks; Worn/holes
Bed Liner
Worn
Bed Pads
Hinge Points
Minor to moderate movement; Hinges show signs of previous heat
Limited Function Check
The main components were operational except as noted.
Chassis #1
Disputes:
This item is offered with IronClad Assurance® protection. With IronClad Assurance®, if a buyer discovers that the item is not substantially in the condition as represented in this inspection report, the buyer may submit a written dispute claim to IronPlanet. Following submission of a written dispute claim, IronPlanet will investigate the claim, re-inspecting the equipment item as necessary, and determine a fair and mutually beneficial resolution. Please note that IronPlanet inspections are performed solely for the purpose of reporting the visible condition of the equipment''s major systems and attachments on the day of the inspection and do not include load testing or digging/lifting. These inspections are not designed nor intended to detect latent defects, or conditions that could only be found in connection with the physical dismantling of the equipment or the use of diagnostic tools or techniques. This inspection report includes ratings, comments, and photos of the various components of the item. Knowledgeable buyers are expected to carefully review all of the available information in the inspection report, including all photographs, in order to make the best bidding and buying decision possible.
Buyer is responsible for all costs related to transporting the item.
Item must be picked up within 8 business days of the auction, or the buyer will incur storage charges.
The location information will be provided once full payment has been received.
Pickup Terms Failure to follow these terms may result in the seller turning away the attempt to pick up the purchased item.
Hours: 7am to 7pm
You must call at least 24 hours in advance to schedule pickup
No Loading Dock, Ramps, or Forklift Available: Only RGN or trailers with ramps can be used to pick up this item at this location. Seller will not allow item to be loaded on a step-deck or flatbed trailer without the appropriate ramps.
Driver MUST bring a copy of the IronPlanet Transportation Release to pick the item up.
Within 3 business days after the auction, the buyer must submit full payment, including applicable taxes and fees.
Buyer must pay a transaction fee, based on the final selling price:
Final Selling Price
Transaction Fee
€1 to €5,000
10% of the final selling price
€5,000 to €31,800
3.85% of the final selling price (min €500)
Above €31,800
€1,225
Payment can be made by wire transfer (recommended), certified bank check (U.S. customers only), or credit card (when full payment amount is $5,000 or less).
All bids are binding and cannot be retracted. Failure to make full payment will result in a Default Fee.
If you are looking to finance your purchase, we recommend you get pre-approved in advance of the auction. Here is a company we recommend who specialize in equipment financing:
Cat Financial
Financing for the way you work Your business is always changing, and so are your financial needs. You need quality equipment to get your work done and financing solutions that make sense for you. Count on a company that understands the work you do.
Warranty by Premium 2000
