Previous Next
ITEM DETAILS
Meter Reading
1,108 Hours
Serial #
8' wide blade, Pad width 16", Diesel engine, 3spd powershift trans, EROPS, Heater, Ripper attachment

Inspection Report



Please note that as the buyer, you are responsible for reviewing the entire inspection report when evaluating an item.
Summary Protected by IronClad Assurance Protected by IronClad Assurance®
Overall this machine is in very good condition. The general appearance is clean and straight. The rest of the machine is mechanically sound showing little wear. See the report for further details.


General Appearance
Description Rating Details  
operators manual Yes
cab/operator station Click here to open photos and videos of this item.  
sheet metal (fiberglass) condition Minor rust spots but fairly straight. Click here to open photos and videos of this item.  
paint Minor scratches and normal wear.
(2)


Engine
Description Rating Details  
hour meter 1108
make & model Cat 3406 Click here to open photos and videos of this item.  
serial # 5KX10206 - Arr. # 6I3535
emission control label None seen
fuel type Diesel
starter
battery
turbocharger NA
exhaust system No visible leaks
cylinder head gasket
oil dipstick tube & bonnet
blowby (checked at idle) Minimal
valve cover gasket
oil pan & gasket
injector pump No visible leaks.
fuel line & injector leaks
water pump
radiator
limited function check Runs strong, with no smoke and no visible leaks.
(1)


Powertrain
Description Rating Details  
transmission type Powershift - 3 Forward and 3 Reverse
torque converter
steering clutches
steering brakes Parking brake also works
drive/propel motors NA
final drives
limited function check Pulls, shifts, turns and stops normal


Chassis
IronPlanet pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Description Rating Details  
push arm/C-frame condition
push arm/C-frame rear pivot points Minimal wear
tilt/angle linkage pins & bushings Minimal wear Click here to open photos and videos of this item.  
blade trunnions or bushings Minimal wear
blade lift linkage pins & bushings Minimal wear
equalizer bar NA
pivot shafts NA
roller frame Has full rock guards Click here to open photos and videos of this item.  
belly pans
limited function check Overall in good condition with minimal play and wear
(2)


Hydraulics
Description Rating Details  
pumps Quiet with no leaks
valves
hoses
cylinders Click here to open photos and videos of this item.  
cylinder pins and bushings Minor play in lift cylinder bushings Click here to open photos and videos of this item.  
limited function check System is strong, smooth and responsive.
(2)


Undercarriage
Undercarriage wear percentages are estimated averages only. These percentages are based on the average measurements of the undercarriage components and may vary due to the machine application, brand of parts, or OEM specifications available.
Description Rating Details  
track tensioners
shoe width 16"
overall width of tracks (outside to outside of track shoes) 6'
grouser height 25% worn
pins and bushings rotated No
track link height 5% worn Click here to open photos and videos of this item.  
pins & bushing wear (internal) Lubricated bushings: Wear percentage not available.
pins & bushing wear (external) Left side - 20% worn. Right side - 40% worn. Click here to open photos and videos of this item.  
carrier rollers 45% worn Click here to open photos and videos of this item.  
track rollers Has full rock guards, unable to measure
front idler height Average 10% worn Click here to open photos and videos of this item.  
rear idler height NA
sprockets Minor front and rear radial wear Click here to open photos and videos of this item.  
limited function check Ran out normal with no unusual noises
(5)


Operator Station
Description Rating Details  
steps/ladders
hand rails
mirrors
glass
seats/armrests Click here to open photos and videos of this item.  
seat belts
horn
exterior lights
engine warning lights/alarms
back up alarm
oil pressure 25lb at idle, 55 lb at high RPM
gauges Click here to open photos and videos of this item.  
hour meter operational Yes
air conditioner NA
heater
hydraulic controls
steering controls
powertrain controls
control lock lever
roll over certification label Yes
limited function check Controls operate smooth and easy. Seems to be in overall good condition.
(2)


Specialty Equipment
Description Rating Details  
blade condition Width 8' Click here to open photos and videos of this item.  
cutting edge condition Reversible edge has not been turned and does not appear to have excessive wear. Click here to open photos and videos of this item.  
ripper condition 5 holes with 4 teeth and shanks Click here to open photos and videos of this item.  
(3)
 
Disputes:
This item is offered with IronClad Assurance® protection. With IronClad Assurance®, if a buyer discovers that the item is not substantially in the condition as represented in this inspection report, the buyer may submit a written dispute claim to IronPlanet. Following submission of a written dispute claim, IronPlanet will investigate the claim, re-inspecting the equipment item as necessary, and determine a fair and mutually beneficial resolution. Please note that IronPlanet inspections are performed solely for the purpose of reporting the visible condition of the equipment's major systems and attachments on the day of the inspection and do not include load testing or digging/lifting. These inspections are not designed nor intended to detect latent defects, or conditions that could only be found in connection with the physical dismantling of the equipment or the use of diagnostic tools or techniques. This inspection report includes ratings, comments, and photos of the various components of the item. Knowledgeable buyers are expected to carefully review all of the available information in the inspection report, including all photographs, in order to make the best bidding and buying decision possible.