Scrapes; Dents; Cracks; Surface rust in areas; Weld repairs; Bent/damaged panels; Engine cover props will not stay up. Cab door cylinder inoperable; See photos for condition
Steps/Ladders
See photos for condition; Bent
Hand Rails
See photos for condition
General Appearance #1
Control Station
Hydraulic Controls
Boot torn
Backhoe Control Configuration
Left stick (Boom and Swing) Right stick (Stick and Bucket)
Glass
See photos for condition; Windshield is scuffed from wiper.
Seats/Armrests
Damaged cushion; Bottom cushion is taped up; See photos for condition
Seat Belts
Operational
Horn
Inoperable
Drivetrain Controls
Steering Control
Oil Pressure
The fault indicator shuts off after the engine oil pressure rises.
Exterior Lights Operational
Some inoperable
Warning Lights
Operational
Travel Alarm
Inoperable
Gauges
Some gauges could not be properly checked during a short operating period.
Hour Meter/Odometer
6,446 Hours; Operational hour meter
- IronPlanet makes no guarantees as to actual hours/miles; we can only report what can be visually observed.
Heater
Fan inoperable some or all speeds
Transmission Disconnect Control
Limited Function Check (cs)
The main components operated except as noted.
Hour Meter/Odometer
Engine
Make and Model
Caterpillar 3054 engine; Serial #: 5HK56442
Fuel Type
Diesel
Emission Control Label
None found
Blow by @ idle (subjective observation)
Visible
Starter
Operational
Turbo or Blower
Operational; Fluid Accumulation
Fuel System
Operational
Exhaust System
Weld repair; See photos for condition
Radiator
Oil Leaks
See photos; Fluid Accumulation: Valve cover; Seepage: Valve cover; Fluid Accumulation: Side of engine; Seepage: Side of engine; Dripping Leak: Side of engine; Fluid Accumulation: Front of engine; Seepage: Front of engine; Fluid Accumulation: Oil Pan; Fluid Accumulation: Rear of engine
Fuel Leaks
None seen
Cooling System Leaks
None seen
Ograniczona kontrola funkcji
The engine started and ran. See oil report.
Blow by @ idle (subjective observation)
Drivetrain
Operational test is limited to low speed in a confined flat area without load. Differential interlocks, full transmission shifting and functionality of all drive axles cannot be fully verified. Inspector listens for abnormal noises, observes leaks and notes physical damage.
Transmission
Operational
Front Drive Axle
Rear Drive Axle
Final Drives
Limited Function Check
The drivetrain was operational.
Drivetrain #1
Hydraulics
Pumps (Hydraulics)
Fluid accumulation
Valves
Fluid accumulation
Hydraulic Tank
Fluid accumulation
Hoses (Hydraulic)
Tractor: Seepage; Tractor: Fluid accumulation
Auxiliary Hydraulic Plumbing
Capped off; Not operationally checked
Loader Lift Cylinders
Minor to moderate pin and bushing movement
Bucket Tilt Cylinders
Fluid accumulation on the center cylinder; Seepage on the center cylinder; Minor to moderate pin and bushing movement
Outrigger Cylinders
Minor to moderate pin and bushing movement
Boom Swing Cylinders
Minor to moderate pin and bushing movement
Boom Lift Cylinder(s)
Minor to moderate pin and bushing movement
Stick Cylinder
Fluid accumulation; Seepage
Bucket Cylinder
Fluid accumulation; Minor to moderate pin and bushing movement
Limited Function Check
The hydraulic system was operational without a load. See oil report.
Hydraulics #1
Chassis
IronPlanet pin connection pivot point wear inspections are limited to sound, sight and feel observations. Dial indicator testing is not performed.
Steering Linkage
Minor to moderate movement
Brake Type
Hydraulic
Master Cylinder
Brake Control
Park Brake
Weak
Limited Function Check
The service brakes performed. The park brake would not hold the machine.
Frame Condition
Tire Size
12.5/80-18 front tires; 19.5L-24 rear tires; Front: Left: Super Trak; Front: Right: Super Trak; Rear: Left: Alpha; Rear: Right: Alpha
Tire Condition
See photos; Cuts; Gouges
Wheel Condition
Wheel Studs, Nuts, Lugs
Lift Arm Condition
Chassis to Arm Pins
Minor to moderate movement
Tilt Linkage Pins and Bushings
Minor to moderate movement
Bucket to Arm Pins
Minor to moderate movement
Limited Function Check
The main components were operational with movement as indicated.
Boom Condition
Scratched
Stick Condition
Scratched
Stick Type
Extendable stick
Stick Extension Wear Guides
Heavy movement; Excessive wear/damage
Boom Lock (Backhoe)
Swing Tower Pivot
Minor to moderate movement
Boom Base Pin and Bushings
Minor to moderate movement
Pin and Bushings Boom to Stick
Minor to moderate movement
Pin and Bushings Stick to Coupler
Heavy movement
Outriggers
Street pads
Limited Function Check
The main components were operational with movement as indicated.
Chassis #1
Specialty
Loader Bucket Condition
7' 5" General purpose loader bucket
Loader Bucket Cutting Edge
Reversible-not turned
Backhoe / Excavator Bucket Condition
18" rear bucket
Backhoe / Excavator Bucket Shanks and Teeth
Worn; Wear
Rear Quick Coupler
Manual rear coupler; Functional
Specialty #1
Oil Sample Analysis
Engine
Hydraulic
date of analysis
May 24, 2012
May 24, 2012
Silicon
104 PPM
5 PPM
Lead
29 PPM
0 PPM
Tin
3 PPM
0 PPM
Copper
15 PPM
29 PPM
Aluminum
48 PPM
0 PPM
Silver
0 PPM
5.8 PPM
Nickel
7 PPM
0 PPM
Chromium
4.2 PPM
0 PPM
Iron
259 PPM
37 PPM
Glycol
NEG
N/A
Water
NEG
NEG
Fuel
>5%
N/A
Disputes:
This item is offered with IronClad Assurance® protection. With IronClad Assurance®, if a buyer discovers that the item is not substantially in the condition as represented in this inspection report, the buyer may submit a written dispute claim to IronPlanet. Following submission of a written dispute claim, IronPlanet will investigate the claim, re-inspecting the equipment item as necessary, and determine a fair and mutually beneficial resolution. Please note that IronPlanet inspections are performed solely for the purpose of reporting the visible condition of the equipment''s major systems and attachments on the day of the inspection and do not include load testing or digging/lifting. These inspections are not designed nor intended to detect latent defects, or conditions that could only be found in connection with the physical dismantling of the equipment or the use of diagnostic tools or techniques. This inspection report includes ratings, comments, and photos of the various components of the item. Knowledgeable buyers are expected to carefully review all of the available information in the inspection report, including all photographs, in order to make the best bidding and buying decision possible.
Buyer is responsible for all costs related to transporting the item.
Item must be picked up within 8 business days of the auction, or the buyer will incur storage charges.
The location information will be provided once full payment has been received.
The buyer will have the option during Checkout to automatically receive competing quotes.
Pickup Terms Failure to follow these terms may result in the seller turning away the attempt to pick up the purchased item.
You must call at least 24 hours in advance to schedule pickup
Driver MUST bring a copy of the IronPlanet Transportation Release to pick the item up.
Within 3 business days after the auction, the buyer must submit full payment, including applicable taxes and fees.
For this item, payment is due on or before June 5.
This item is subject to Wisconsin sales tax. (Read more)
Buyer must pay a transaction fee, based on the final selling price:
Final Selling Price
Transaction Fee
$1 to $5,000
10% of the final selling price
$5,001 to $32,500
3% of the final selling price (min $500)
Above $32,500
$975
Payment can be made by wire transfer (recommended), certified bank check (U.S. customers only), or credit card (when full payment amount is $5,000 or less).
All bids are binding and cannot be retracted. Failure to make full payment will result in a Default Fee.
If you are looking to finance your purchase, we recommend you get
pre-approved in advance of the auction. Here are three companies we recommend
who specialize in equipment financing:
GE Capital
Thank you for your interest in applying for a GE Capital loan. GE Capital
provides equipment leasing, financing and other services to deliver significant
benefits for your business. Our products and services are customized with
flexible structure and payment terms to match your unique needs and goals. In
order to start the process of applying for a loan, please complete the attached
credit
application and email it to Ron Hayes or fax it to 1+866-401-5114.
Cat Financial - Capital Solutions
Get a Pre-Approved Line of Credit Be prepared for
upcoming auctions by arranging a line of credit from Cat Financial. Time is
money during an auction, and seconds count. Let Cat Financial provide you with
the pre-arranged purchasing power that lets you focus on the equipment you need.
Apply today.
Trucks
If you wish to finance your truck purchase, we recommend that you get pre-approved before the auction.
DriveItNow provides pre-qualification for IronPlanet trucks. Through DriveItNow, you can securely pre-qualify for financing online without providing confidential information such as your social security number or date of birth. There is also NO impact on your credit score. Click on the monthly payment or “Get Financing” link from any live auction truck listing to get started. DriveItNow is a service provided by ACS (Automobile Consumer Services, Inc.)
Warranty by Premium 2000
